Will the prints last in a hot car?

Our turn signal extensions are printed in Polyethylene Terephthalate Glycol which withstands heats up to 80°C or 176°F, by far resistant enough to last in the hottest climate.

Will it fit my car?

If you are worried they won’t fit your vehicle you can always confirm by contacting us at support@blink3d.ca or use the Custom Builder for an exact fit.

What do the turn signal extensions accomplish?

Our turn signal extensions are built for vehicles with aftermarket steering wheels to compensate for length added from the steering wheel and hub, as well as adding a touch to your interior.

Are they strong?

Our turn signal extensions are about 20% stronger than ABS plastics and will easily last through daily wear and tear.

Recommendations for install?

We recommend adding the supplied foam as you see fit, tightening the turn signal extender finger tight, and using a semi-permanent threadlocker.